Single Wall Flue Pipe

Heat Design single wall components are generally used  to make the connection between a stove or cooker and the chimney. The chimney may be clay lined masonry, flexi lined masonry or a twin wall system. Single wall components should be fitted at least three times their diameter away from combustible materials.

 

Straight Length

Single Wall straights are available in both 5″ and 6″ and in three lengths. They can be easily combined to achieve the required flue run. Always face the male end downwards when fitting to ensure any moisture flows down the pipe internally.

 

Single Wall StraightStraight length

 

 

Straight Length with Cleaning Door

Single Wall straights are available in both 5″ and 6″ and in three lengths. They have a cleaning door, for access to inspect or clean the pipe.

Single wall straight with cleaning doorStraight length cleaning door copy

 

 

90 Degree Bend with Cleaning Door

This component is used when a 90 degree change in direction is required, and also provides access via a cleaning door. It is made in 3 segments.

Single wall 90 degree bend with cleaning door90 bend

 

 

90 Degree Tee with Cap

This component is used when a change in direction from horizontal to vertical is required. The pipe comes with a tee cap which provides access for inspection or cleaning.

Single wall 90 degree tee with cap90 tee

 

 

45 Degree Bend 

This component is used when a 45 degree change in direction is required. This component minimises the resistance of the flow of the flue gas because of the angle created with the vertical axis.

Single wall 45 bend45 bend

 

 

20 Degree Bend – available in 6″

This component is used when a 20 degree change in direction is required.

Single wall 20 degree bend

 

 

Flue Pipe Reducer

This component is availble in 2 sizes and is used to connect both 5″ and 6″ single wall or flexi flue pipe to a standard 8″ clay liner. It is made from 0.7mm stainless steel.

Single wall flue pipe reducerflue reducer

 

 

Anti Bird Anti Rain Cap

The raincap is fitted to the top of a standard clay chimney and is used to ensure rain or snow cannot enter the chimney, whilst ensuring the exit of flue gases is not impeded. Our rain caps are all fitted with an anti-bird mesh.

Single wall anti bird anti rain

 

 

Flue Collar with Damper

This can be fitted to any Heat Design free standing stove and is used to control the chimney draught if the draught is too strong.

Single wall flue collar with damper

 

 

Flue Pipe Offset Reducer

This component is available in 2 sizes, 5″ and 6″, and in 3 different offsets. it is used to connect single wall or flexi flue to a standard 8″ clay liner. It is particularly useful if the clay flue pipe is off centre.

Single wall offset reducer

 

Share this product